Apollo Sprayers MOBILE MIST T100-S Instruction Manual - Page 5

Browse online or download pdf Instruction Manual for Personal Care Products Apollo Sprayers MOBILE MIST T100-S. Apollo Sprayers MOBILE MIST T100-S 13 pages. Tanning system

Print Page
Set up and operate your T100-S Mobile Mist™ Spray Tan System:
1
Separate the middle section of the Mobile Mist case by releasing the three latches. You will find the air hose.
Remove the air hose. Close the middle section by securing the three latches. Open the top section by releasing the
single latch. You will find the Mist Applicator, power cord and instruction manual. Remove the Mist Applicator, power
cord and instruction manual.
2.
Connect the power cord to the Mobile Mist™ Turbo spray unit. Then, plug the power cord into
a proper electrical outlet. Make sure that the electric current you are connecting to is the same as your
unit. (110v or 220v). DO NOT attempt to connect the unit to the wrong electric current as this will not
only damage your unit but also void your warranty.
3.
Next, locate the male end of the air hose and connect it to the outlet on the Mobile Mist™
Turbo Spray unit.
a. To insert the coupler pull back on the ring of the black coupler and connect it to the outlet on the T100-S Mobile
Mist™ Turbo Spray unit.
b. Release the ring to allow the coupler to snap into place. The hose should now be connected to the unit.
c. To remove the air hose, pull back on the ring of the black coupler and remove.
CAUTION: If you have just finished spraying, the connector may be hot. Allow the Mobile Mist™ Turbo unit to cool
down for about 10 minutes before disconnecting the air hose from the turbo unit. Use Caution!
The top section is also designed for storage of various solutions, towels and other accessories. When left open
during a tanning session the Mist Applicator can be safely secured in a vertical position to avoid spillage of solution
when not in use.
MIST APPLICATOR