Addspace 033 7500 Series Step By Step Assembly Instructions - Page 5

Browse online or download pdf Step By Step Assembly Instructions for Indoor Furnishing Addspace 033 7500 Series. Addspace 033 7500 Series 6 pages.

Print Page
STEP 4
ATTACH BOTTOM TO ENDS AND DIVISION
LOCATE SCREWS kk
THROUGH HOLES
IN BOTTOM 5730
AND SCREW INTO
HOLES IN ENDS
AND DIVISION.
STEP 5
YY
XX
DIAG 1
YY
XX
YY
XX
DIAG 2
YY
XX
YY
XX
DIAG 3
YY
XX
STEP 6
hh
ii
ALIGN BACK PANEL (5735)
SO THAT THERE IS A EQUAL
GAP FROM THE EDGE OF
END PANEL AND
DIV PANEL THEN
SECURE THIS IN PLACE.
USE THE NAIL GUIDE WHEN
LOCATING THE NAILS.
THIS WILL HOLD THE NAILS
VERTICAL AND ENSURE THE
CORRECT DISTANCE FROM
THE EDGE.
Fittings you will need in this step:
(x6)
TURN UNIT OVER SO THAT THE FINISHED EDGES ON TOP/BOTTOM ARE TO
THE FLOOR(2 PERSONS) AND SQUARE UNIT UP
IMPORTANT!
ENSURE A TAPE
MEASURE IS USED
TO SQUARE UP UNIT!
BEFORE SECURING THE
BACK IT IS NECESSARY
TO SQUARE UP THE UNIT.
YOU CAN DO THIS BY
MEASURING BETWEEN
XX-XX AND YY-YY
ENSURING THESE ARE THE
SAME (DIAG 1). IF THEY
ARE NOT (DIAG 2) APPLY
SLIGHT PRESSURE AS
INDICATED (DIAG 3) UNTIL
THEY ARE THE SAME.
ATTACH 3mm BACK PANEL
Fittings you will need in this step:
hh
ii
(x20)
(x1)
THE BACK PANEL IS TO BE
POSITIONED TO COVER THE
BACK OF THE DRAWER
SPACE.
YY
XX
IF YOU HAVE DECIDED TO HAVE A LEFT HAND
DRAWER THE BACK PANELNEEDS TO BE
POSITIONED ON THIS SIDE.
hh
PAGE 5
XX
YY
MEASURE TO
EXTERNAL
CORNERS.