ELRO K2 CONNECTOR Manual - Page 5
Browse online or download pdf Manual for Security Sensors ELRO K2 CONNECTOR. ELRO K2 CONNECTOR 15 pages.
Print Page
1.2
LED indication
Yellow : Flashes 3 times or is on continuously, the K2 Connector is not connected or cannot
connect to your Wi-Fi.
Green : Flashes 3 times and then on, the K2 is connected to your Wi-Fi.
Green : Blinks per second, accessories can be added.
Green : On is Home scene.
Blue
: Blinks per second, the K2 is ready to connect to your Wi-Fi.
Blue
: On is Away scene.
Purple : On is Sleep scene.
Red
: Flashes every 2 seconds, indicates alarm of devices.
Red
: Flashes every 5 seconds, indicates unread alarm messages.
1.3
Installation failed
1.
Unplug the connector and wait 10 seconds.
2.
Press and hold the connector button until a sound is heard.
3.
Insert the connector back into the socket and go through the installation again, keeping in
mind the installation tips below.
1.4
Installation tips
•
Make sure the 2.4GHz network is selected on the smartphone.
•
Wi-Fi name and password do not contain spaces.
•
Give permission for all permissions requested.
•
Does the connector flash blue when going through the installation?
•
Are you sure the password is correct? Click the eyelet for verification.
•
Make sure the 2.4GHz signal is Wi-Fi 4 or lower (802.11n).
•
If the above does not cause the problem, it could be that the Wi-Fi network consists of a
combined signal of both 2.4 and 5GHz. By logging in to the router, the 5GHz signal can be
temporarily disabled before installation. After installation, this signal can be enabled again. If
you don't know how to do this, you can contact your internet service provider. They can
easily enable this signal remotely for you.
- 5 -