DUSK Ascot Manual - Page 17

Browse online or download pdf Manual for Indoor Furnishing DUSK Ascot. DUSK Ascot 17 pages. Ottoman bed frame
Also for DUSK Ascot: Manual (16 pages)

Print Page

Care and Maintenance

Here are some good tips to keep your new ottoman bed frame in tip-top condition.
Cleaning
To clean your new ottoman bed frame, we advise using a damp cloth if the fabric is dusty or a
low suction vacuum. Do not use abrasive chemicals or bleach as this may damage the
product.
Checking and Moving
Periodically, we recommend you check that the screws and fixtures haven't become loose
over time. To move your bed frame, we recommend lifting it where possible, as dragging or
pushing it could cause damage to the legs or flooring.
Fabric
Please note, depending on the Iighting, positioning and surroundings of your room, the shade
of the fabric will appear differently. Over a period of time, the fabric may also
lighten or fade slightly due to light exposure.
Gas strut/piston best use:
•
Use caution when operating - always use two hands.
•
Only attempt to close the ottoman frame, once the mattress has been placed on the frame.
The thicker side of the cylinder should be above the thinner side - this will increase longevity
ofthe part.
•
Only attempt to close the frame with two hands from the footboard side, slowly increasing
the pressure until the frame starts moving downwards.
•
Closing the frame for the first time may be difficult, as the cylinder needs cycling and
lubricating. After closing for the first time, open and close a further 5 times.
•
If the frame is stuck open and unable to be closed, we recommend getting assistance from
a second person, both applying equal pressure from each side of the footboard until the
frame closes, this may require more force than expected. Stop applying pressure if the metal
frame begins to warp – contact customer services at this point.
Top tips:
•
Do not attempt to close the gas strut/piston by hand, it can only be compressed once
added to the frame
•
Ensure the frame can move freely before adding the gas struts/pistons
•
Check the frame is fully square, being offset can cause the frame to catch on the side rail