Datalogic DS2100A Quick Reference Manual
Browse online or download pdf Quick Reference Manual for Barcode Reader Datalogic DS2100A. Datalogic DS2100A 10 pages. Laser barcode reader
Print Page
1
Mounting Holes
2
Laser On LED
3
Good Read LED
4
External Trigger LED
For further details on product installation, see the
complete Installation Manual.
DS2100A can be configured through the WinHost
Windows-based software program available on the
installation CD-ROM.
For configuration it is necessary to create a cable
connecting the scanner to the PC as indicated in the
"How To Build A Simple Interface Test Cable" section of
this guide.
POWER SUPPLY
- This product is intended to be installed by Qualified
Personnel only.
- All Models:
This accessory device is intended to be supplied by a UL
Listed or CSA Certified Power Unit with «Class 2» or LPS
power source which supplies power directly to the
scanner via the 25-pin connector.
DS2100A
Laser Barcode Reader
Quick Reference Guide
1
2
3
6
Figure A
Power On / Data TX LED
5
Warning and Device Class Labels
6
Accessory Mounting Holes
7
Laser Beam Output Window
8
The scanner is classified as a Class 2 laser
product according to EN 60825-1 regulations
and as a Class II laser product according to
4
CDRH regulations.
5
Disconnect the power supply when opening the
device during maintenance or installation to
avoid exposure to hazardous laser light.
There is a safety device which allows the laser to
be switched on only if the motor is rotating above
the threshold for its correct scanning speed.
The laser beam can be switched off through a
software command (see also the WinHost Help
On Line).
7
N2468
8
218441
C
Warning and Device Class Labels
The laser diode used in this device is
classified as a class 3B laser product
according to EN 60825-1 regulations and as a
Class IIIb laser product according to CDRH
regulations. As it is not possible to apply a
classification label on the laser diode used in
this device, the following label is reproduced
below.
EMITTED WAVE LENGTH 630~680 nm
Laser Diode Class Label
Any violation of the optic parts in particular
can cause radiation up to the maximum level
of the laser diode (35 mW at 630 to 680 nm).
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
MAX. OUTPUT RADIATION 1 mW
EMITTED WAVE LENGTH 630~680 nm
TO EN 60825-1:2001
CAUTION-CLASS 3B LASER LIGHT
WHEN OPEN AVOID EXPOSURE TO BEAM
This product conforms to the applicable
requirements of 21CFR1040 at the date
R
of manufacture.
US
LASER LIGHT
AVOID EXPOSURE TO BEAM
CLASS 3B LASER PRODUCT
MAX. OUTPUT RADIATION 35 mW
TO EN 60825-1 (2001)