Datalogic DS2x00N-DS4800 Series Setup Procedure Using Programming Barcodes - Page 14

Browse online or download pdf Setup Procedure Using Programming Barcodes for Barcode Reader Datalogic DS2x00N-DS4800 Series. Datalogic DS2x00N-DS4800 Series 20 pages.

Print Page
5 NETWORK STATUS MONITOR LOCK – UNLOCK BARCODE
For Master scanners with display (or connected to a CBX500 with accessory display), the
Network Status Monitor shows diagnostic messages regarding the network. It can be
enabled/disabled through two different methods:
by means of a Genius™ parameter
with a programming barcode
The programming barcode procedure uses the AutoLearn Mode as described in chapter 1.
The code below is a "toggle-code":
if the Network Status Monitor is disabled, the programming code enables it.
if the Network Status Monitor is enabled, the programming code disables it.
Network Status Monitor
On the Master display the following messages are shown:
1
*
1
-
Where:
*
=
Device OK
-
=
Device not detected at startup
?
=
Device detected at startup but not responding to polling
!
=
Device with diagnostic error
The DS4800 has a two-line display and so the messages alternate.
14
Ì$+NETDISP$-GÎ
Network Status Monitor
N
e
t
*
*
*
*
-
-
6
N
e
t
-
-
-
-
-
-
Setup Procedure Using Programming Barcodes
w
o
r
k
-
-
-
-
-
-
w
o
r
k
-
-
-
-
-
-
1
5
-
-
3
1
-
-
-