Datalogic DS4800 Quick Reference Manual - Page 9
Browse online or download pdf Quick Reference Manual for Barcode Reader Datalogic DS4800. Datalogic DS4800 13 pages.
Also for Datalogic DS4800: Quick Reference Manual (13 pages), Quick Reference Manual (16 pages)
Print Page
MECHANICAL INSTALLATION
DX8200A-3002 can be installed to operate in any position. There are 4 slots (dia. 8.5 mm) on the sides of the
scanner for mounting. The diagram below can be used for installation; refer to the Reading Diagrams for correct
positioning of the scanner with respect to the reading zone and scanner orientation.
=
22
[0.87]
=
=
When installing several scanners, take care to position them correctly so that no laser beam
enters the reading window perpendicularly and at the same level of the output beam of the
other scanners. This condition could occur more frequently for side mounted applications. If
these precautions are not followed, it may occur that the laser of the blinded scanner starts
blinking due to an internal circuit which temporarily turns the laser off when detecting a
WARNING
power anomaly. To resolve this problem, it is sufficient to slightly change the inclination and
position of one of the two scanners involved.
Mounting Stops
X
Two washers and two spacers are provided in the DX8200A package to create two stops which can be used to
facilitate DX8200A mounting and positioning. Create each stop by mounting a washer and spacer to the Reading
Station Frame using Bosch T-bolts and nuts. See the figure above.
During initial mounting, affix the stops in approximation to the mounting position. The weight of the DX8200A
can rest against this reference while the mounting bolts are being set. This avoids having to hold and maneuver
the scanner (especially for vertical side mounted positions) while simultaneously affixing it to the frame.
470
[18.50]
406
[15.98]
370
[14.57]
370
[14.57]
DX8200A-3002 Overall Dimensions
Z
Y
X-axis Reference Point Stops
DX8200A-3002 QUICK GUIDE
=
PackTrack™ Coordinate Reference Point
where x, y, z = 0
22
[0.87]
=
=
Create
using
spacer, t-bolt and nut.
the
stop
by
the
washer,
9