Elsner Corlo Touch KNX Technical Specifications And Installation Instructions - Page 7
Browse online or download pdf Technical Specifications And Installation Instructions for Switch Elsner Corlo Touch KNX. Elsner Corlo Touch KNX 12 pages. Display and touch switch
Also for Elsner Corlo Touch KNX: Technical Specifications And Installation Instructions (2 pages)
Print Page
Connect KNX bus, auxiliary voltage und where required the breakout cable for analog/
digital inputs to the display unit.
Wall
Display Corlo Touch KNX • Status: 06.08.13 • Technical changes and errors reserved.
7
Fig. 4
If the screw domes of the box used are not
covered with the frame's longitudinal holes,
the frame can alternatively be bolted via the four
outside holes (e.g. for boxes from Swiss systems
or other installation systems).
Fig. 5
The display unit can now be put in place.
The wider part of the display surround must
be at the bottom.
The display unit engages on the right and left
sides and is also held by magnets.
Fig. 6
To remove the display unit from the frame, press
one of the snaplock connections on the side of
the device with a sharp instrument. You can now
pull the device to the front at the unlocked side
und remove it.
Installation and start-up