Dust Free BIO-FIGHTER Ultra-Flex 1S Installation & Operation Manual - Page 4

Browse online or download pdf Installation & Operation Manual for Lighting Equipment Dust Free BIO-FIGHTER Ultra-Flex 1S. Dust Free BIO-FIGHTER Ultra-Flex 1S 7 pages. Ultraviolet light systems

Print Page

BIO-FIGHTER® ULTRA-FLEX INSTALLATION & OPERATION MANUAL

INSTALLING THE LAMP HOUSING(s)

After lamp has been installed, reinstall the

remote lamp housing using the knurled nuts.

The remote lamp housing must be in place

prior to attaching the electrical harness.

Fig. 4 Reinstall lamp housing.

CONNECTING THE HARNESS

Attach the connector to the lamp. Hold back the

protective boot to expose the harness connector.

The harness connector is asymmetrical and can

only be attached one way. If the harness does

not attach easily, rotate 90 degrees and try again.

After the harness connector is attached, slide the

protective boot over the lamp/connector. The pro-

tective boot fits snugly over the lamp and seals

the connection from moisture, dust, etc.

Fig. 5 Attach lamp harness to lamp. The plastic boot slips over

the lamp and seals the connection from moisture.

(Fig.4 )

(Fig.5)

OPTIONAL INTERNAL LAMP MOUNTING

Use the optional lamp bracket(s) to install the

entire lamp assembly inside the AHU.

Install the lamp bracket(s) at the desired loca-

tion with two self-drilling screws. (Fig. 6)

Insert lamp base into bracket, slide lamp

retaining washer over lamp and fasten using

two knurled nuts. Use knurled nuts from

remote lamp housing.(Fig. 7)

Connect harness to lamp. Refer to "Connecting

The Harness" on this page for details.

Fig. 6 Install lamp bracket inside air handler

Fig. 7 Attach lamp to bracket.

WARNING

UV-C Light Hazard.

UV-C light can cause temporary or permanent loss of

vision, and sunburn. Take precautions to protect eyes

and skin from direct exposure.