Dust Free LightStick Installation & Operation Manual - Page 3
Browse online or download pdf Installation & Operation Manual for Steriliser Dust Free LightStick. Dust Free LightStick 5 pages. Germicidal ultraviolet light
Print PageDUST FREE
®
LIGHSTICK™/ LIGHTSTICK™ PLUS INSTALLATION & OPERATION MANUAL
W-COIL / ABOVE A-COIL INSTALLATION
• Disconnect power to the air handler and
open access panels.
• Magnetic Bracket Installation - Slit
insulation on the back or side wall of air
handler and attach magnetic bracket to
the wall.
• Standard Bracket Installation - Install the
lamp bracket at the desired location with
two self-drilling screws (included).
• Secure the lamp to the lamp bracket with
the provided knurled nuts.
• Connect remote mount lamp power cord.
A-COIL DELTA PLATE INSTALLATION
• Drill a 7/8" hole into the delta plate and
place gasket (included) around hole.
• Insert lamp directly into hole and secure
the lamp to the delta plate with two
self-drilling screws. (Screws and rubber
washers Included.)
• Connect remote mount lamp power
cord. Note: A-Coil delta plate
installation does not use lamp bracket.
NOTICE
Clean lamp prior to installation.
Use a cotton cloth to remove dirt and fingerprints. Failure to clean the lamp
could shorten the lamp's lifespan.
WARNING
UV Light Hazard.
Can cause serious eye and skin damage.
Do not look at UV-C light. Wear UV-C eye and skin protection
(Remote Lamp)
Fig. 2 Attach lamp to lamp bracked and install
in desired location.
(Remote Lamp)
Fig. 3. Insert lamp into delta plate hole and se-
cure with screws and washers. Connect remote
lamp power cord.
DUST FREE
®
LIGHSTICK™/ LIGHTSTICK™ PLUS INSTALLATION & OPERATION MANUAL
A-COIL DELTA PLATE INSTALLATION
• Drill a 7/8" hole in the outer sheet metal
where the lamp will be centered on the
return side of the coil. See diagram.
• Place gasket (included) around hole.
• Insert lamp into power module and
secure with self-drilling screws.
(Included.)
• Insert lamp/power module assembly
directly into hole and secure with self-
drilling screws (Included.) Note: A-Coil
delta plate installation does not use
lamp bracket.
NOTICE
Clean lamp prior to installation.
Use a cotton cloth to remove dirt and fingerprints. Failure to clean the lamp
could shorten the lamp's lifespan.
WARNING
UV Light Hazard.
Can cause serious eye and skin damage.
Do not look at UV-C light. Wear UV-C eye and skin protection
(Direct Connect™)
Fig. 4 Insert lamp into power module and
secure with screws.
Fig. 4A Insert assembly into delta plate hole
and secure with screws.