Dust Right 650 CFM Instruction Manual - Page 6

Browse online or download pdf Instruction Manual for Dust Collector Dust Right 650 CFM. Dust Right 650 CFM 8 pages. Wall-mount dust collector
Also for Dust Right 650 CFM: Instructions Manual (8 pages)

Print Page

Stud locations

Cleat

Fig. 3

Z-Bracket Mounting on a Finished Wall

1. Determine where you want to mount your Wall Mount

Dust Collector.

2. Use a stud finder to locate two wooden wall studs. Mark

the locations.

3. Measure the distance between the two wall studs and cut two

pieces of 2 x 4 material long enough to span both studs. You

will screw these cleats to the wall studs and then mount the

Z-Bracket (11) to one of these cleats; the other cleat will

support the bottom of the larger black Base (1) on the

dust collector. Fig. 3.

4. Place one of the cleats at the desired mounting height, and

use a level to make sure it's straight.

5. At each end of the cleat, drill two 1/8" pilot holes through

the cleat and into the studs and drive two #10 x 3"

screws (not included).

Cleat

Fig. 4

4. Attach the second 2 x 4 mounting cleat about 8" down from

the bottom of the first, using the same methods. Fig. 3.

5. Position the Z-Bracket (11) on the top cleat as desired, use a

level to make sure it's straight, and use the holes in the bracket

to mark locations for pilot holes.

6. Drill 1/8" x 1

⁄

" deep pilot holes at each location.

7. Secure the Z-Bracket (11) to the top cleat with the

included #10 x 1

but don't overtighten. Fig. 4.

8. Fit the Dust Right

Z-Bracket (11), making sure the bracket is between the left

and right limit stoppers. Fig. 4.

Limit

Stopper

⁄

" Wood Screws (12). Fully tighten,

Wall Mount Dust Collector onto the