4LIGHT 40601 User Manual - Page 3
Browse online or download pdf User Manual for Lighting Equipment 4LIGHT 40601. 4LIGHT 40601 4 pages.
Print PageMaintenance: The harness is to be concidered as workwear. Hand wash only.
The harness electronics does not withstand machine wash.
Recycling:To reduce the environmental impact, recycle the battery. Recycle
the worn-out harness as electronic waste.
PCB: The Main PCB is positioned on the left side of the harness
There are three switches that controls the LED lights.
Switch 1: Controls the white front work light.
Switch 2: Controls main on/off.
Switch 3: Controls the shoulder- and rear lights.
Configurations: There are different configuration of LED strips and program-
ming depending on the use of the harness. Configurations as following:
Nova Standard: (White front LED, yellow shoulder LED's, red rear LED)
Switch 1: Operates white work light (front): Dimmable 25%, 50%, 75%, 100%,
Off
Switch 2: Main On/Off
Switch 3: Operates yellow shoulders and red rear LED strips in following sequ-
ence: Alternating shoulder with static rear light on – alternating shoulder with
rear light off – Parallel shoulders with static rear light on – parallel shoulders
with rear light of – static rear light on – Off
Nova Rail: (White front LED, yellow shoulder LED strips, yellow rear LED). All
other features are same as Nova Standard.
On the top of the PCB there are two LED-lights:
Diode 1: Indicates if the harness is on. Note that if diode 1
is on and all LED-lights are off, the harnessis in a standby
mode.The included Power bank has an auto-off function. If
the harness is in standby mode it will go in off-mode after 17
seconds. When this happens, quickly press the main switch
(2) two times and the harness will restart again.
Diode 2: Indicates if the rear LED-light is on.