CBC ZC-OH5 Instruction Manual - Page 3
Browse online or download pdf Instruction Manual for Camera Accessories CBC ZC-OH5. CBC ZC-OH5 8 pages. Tamper-resistant indoor/outdoor housing
Print Pageb) Using a minimum 1/2" drill bit, drill the cable feed hole and feed the
video/power cable through the mounting surface or attach 3/4"
conduit fitting to the hole in the side and seal with pipe thread tape
(see F
IGURE
F
IGURE
B
V
C
ACK
IEW
ONDUIT
Built-in Conduit Hole
c) Holding the dome against the mounting surface, mark and drill the 4
mounting holes (see F
surface using the supplied #8 Phillips screws, rubber washers and
plastic anchors (anchors for dry wall only), (see F
Depending on the mounting surface other hardware may be needed.
Add rubber gasket seal to the back of the housing for sealing on a
flat surfaces. For uneven surfaces a bead of silicone sealant is
recommended.
Note: If using other mounting hardware; apply silicone sealant
around the inside of the 4 mounting holes before inserting screws or
bolts to prevent damage from leakage.
F
IGURE
D
OME
Rubber mounting
washers (x4)
Mounting
Screws (x4)
2).
2
H
OLE
IGURE
1
R
EMOVAL
Loosen (x3) Set Screws
to remove trim ring and
bubble.
I
B
NSIDE
ASE
Mounting holes for camera base (2)
Mounting holes for housing,
covered by rubber plugs (4)
3). Fasten the base to the mounting
3
Cable Assembly
Plastic anchors (x4)
for drywall only.
F
3
IGURE
M
H
OUNTING
1).
IGURE
OLES