CBC EN7-S02T Quick Start Manual - Page 5

Browse online or download pdf Quick Start Manual for Thermal cameras CBC EN7-S02T. CBC EN7-S02T 11 pages.

Print Page

Configure the Computer

The factory default values of the device are as follows:

IP Address: "192.168.1.88"

IPv4 address of the PC needs to be in the same network

segment with the IP address of the IP camera for normal

operation. Specific settings in window system can refer to the

following methods:

Step 1: Check the IPv4 address of PC, click "Start"/ "Control

Panel" / "Network and Internet" / "Network and Sharing

Center" / "Local Network" / "Details". If you have an IP of

192.168.1.X, you can add the device directly on the platform.

If there is no IP address on this network segment, proceed to

step 2 to increase the IP address on this network segment.

Step 2: Click "Close" → "Properties", double-click "Internet

Protocol Version 4 (TCP / IPv4)", click "Advanced" → "Add"

under the IP address, enter the same network segment IP as

the device (such as 192.168.1.165) → "Add" → "OK"

→ "OK" → "OK", add IP and exit.

Password: "12345"

The IPv4 address cannot be

Note

conflicted when you add in

LAN.

Port : "7080"