Dutch&Dutch Studio 8m. Owner's Manual - Page 10

Browse online or download pdf Owner's Manual for Subwoofer Dutch&Dutch Studio 8m.. Dutch&Dutch Studio 8m. 15 pages.

Print Page

Product operation

Connecting to mains power

The 8m accepts AC mains voltages between 85 and 265 V and net frequencies between 47 and
65 Hz. There is no difference in amplifier output power between 120 V and 230 V mains voltages.
An IEC power cord, suited to your regional power outlets, is supplied with the 8m. Plug it into
the IEC receptacle (13), then plug the other end into your wall socket.

Status LED

The logo on the 8m's front (3) doubles as a status indicator.
·
Off: the loudspeaker is switched off entirely
·
Dimmed pulse: the loudspeaker is in standby mode
·
Bright pulse: the loudspeaker is muted
·
Quick pulse: there is an error. Open the Dutch & Dutch app to see what is wrong. Alternatively,
try performing a software reset (see "Settings pushbutton"). If the fault can not be remedied,
contact your Dutch & Dutch representative.
·
On: the loudspeaker is switched on.
In case the illumination of the logo is undesirable, it can be dimmed or switched off from the
Dutch & Dutch app. Please keep in mind that the loudspeaker's status can only be monitored
through the app in this case.

Connecting to a local area network

The 8m has an RJ45 receptacle (11), which can be used to connect it to your local area network
(LAN), allowing the Dutch & Dutch app to find your speakers.

Audio input

The 8m can be connnected to either digital (AES3) or (balanced) analog sources. There is one
female XLR connector (6) that can be used to present these signals to the 8m. Make sure the
correct preset is selected (see "Settings pushbutton").
Although it is possible to connect unbalanced sources with adapter cables, Dutch & Dutch
strongly recommends that balanced sources are used in order to obtain optimal gain and
sound quality.

Looping output

There is a male XLR loopthrough (7) connector that can be used to loop the signal to another
8m. Make sure that both loudspeakers are set to the correct AES3 channel in case you are
looping an AES3 signal (See "Settings pushbutton").
10