Dataprobe iBoot Manual - Page 10

Browse online or download pdf Manual for Switch Dataprobe iBoot. Dataprobe iBoot 20 pages. Web enabled remote power control
Also for Dataprobe iBoot: Instruction Manual (16 pages)

Print Page

1. Setting Ip Address

iBoot Ver 1.5

Page 10

3. Setting the IP address using the ibootrst.exe

Dataprobe provides an iBoot Reset Program; ibootrst.exe to

easily reset the IP address, as well as set the factory defaults in

the event the security code is lost. Obtain ibootrst.exe from

Dataprobe's web site. You can either download ibootrst.exe or

iboot.exe, which provides an iBoot control program as well.

For ibootrst.exe:

http://www.dataprobe.com/files/power/ibootrst.exe

For iboot.exe:

http://www.dataprobe.com/files/power/iboot.exe

To use ibootrst.exe, the computer running the program must be

on the same subnet and network segment as the iBoot is to be

programmed to. Same subnet can be directly connected or

connected through Ethernet hubs. (NOT routers or switches)

To use ibootrst.exe

Enter the MAC address found on the

underside of the iBoot and the desired

IP address. Click on the Set IP

Address bar. ibootrst.exe will confirm

the proper setting of the address. If

you receive an error message, check

the MAC and IP addresses.

Click the

button for information about the utility program.