Dux DYNAMIC 19 Assembly Instructions - Page 3

Browse online or download pdf Assembly Instructions for Indoor Furnishing Dux DYNAMIC 19. Dux DYNAMIC 19 5 pages. Queen/cal.king/152/160/180

Print Page

DUX, DUXIANA and DUX Pascal-systems are registered trademark owed by Dux Design AB 2012.

Printed 2021.02.01

IV. TURN THE BED BASES BACK AROUND

AND CLOSE TOGETHER

Place the bed bases close together.

V. RAISE THE HEAD- AND FOOT-END

Plug the motors into the outlets.

Raise the head- and foot-end

to the maximum height.

VI. MOUNT THE CONNECTIONPLATES

A At the head-end of the bed, remove

3 of 4 screws leaving the second

from the right below.

Loosen the remaining screw so that the

connection plate can slide between

the bed and the screw.

B Attach the connection plate with

the first screw on the left. Rotate the

connection plate so the slot goes

over the screw.

C Add the rest of the screws and tighten.

Repeat at the foot-end.

dux.com

VII. MOUNT THE RETAINER BAR

While the head- and foot-ends are

raised, mount the retainer bar.

Remove the screws at the foot-end

and use them to fasten the

retainer bar to the bed.

VIII. ADD THE COVER STRIP

Add the cover strip to conceal the split

between the two panels

at the head- and foot-ends.

IX. LOWER THE BED

AND ADD THE SPRINGTOP

Lower the bed to the original flat position

and add the springtop with

the split at the head-end of the bed.

dux.com

DUX, DUXIANA and DUX Pascal-systems are registered trademark owed by Dux Design AB 2012.

Printed 2021.02.01