Dux Platinum 3000 Series Product Manual - Page 17

Browse online or download pdf Product Manual for Power Tool Dux Platinum 3000 Series. Dux Platinum 3000 Series 20 pages. Pressure feed

Print Page

Problem

Coating leakage

out of the tip of spray gun

Split

Pattern

Heavy Right

or left side

pattern

"Orange Peel"

heavy pattern

Heavy top or

bottom pattern

Will not

spray

Spray gun

sputtering

Spray pattern

starved or dry

Excessive

Fog

For customer service call 888.389.2732

PLATINUM PRESSURE FEED

Troubleshooting

Cause

Foreign material is interfering with seal

between fluid tip and needle

1. Air Pressure too high

2. Fluid flow to low

Dirty or damaged air cap/holes

1.Air pressure is to low

2.Spray gun is too close to working

surface

3.Fluid adjustment is too high

1. Air cap dirty or damaged

2. Fluid tip dirty or damaged

1.Insufficient air pressure

2.Insufficent fluid settings

3. Fluid too heavy for current settings

4. Plugged fluid tip

1. Damaged fluid tip

2. Loose fluid tip

3. Dried material in fluid tip/needle

4. Fluid supply empty/low

5. Packing nut too loose

1. Air pressure too high

2. Fluid adjustment too low

3 .Spray too far from working surface

The Dux Pressure Feed was designed to

eliminate excessive fog. If you find that

you are having this problem, it may be

that the air pressure too high

Solution

1. Remove fluid tip and needle

2. Look for small bits of dried paint or

other foreign material

3. Clean thoroughly and reinstall

1. Reduce inlet air pressure

2. Turn fluid control knob counter-clock-

wise

Note: If setting is at 4A replace fluid tip

with next largest size

Clean Air Cap

Note: If problem persists after cleaning,

replace air cap

Note: Do not use metal tools to clean

air cap

1. Increase inlet air pressure

2. Ensure proper distance from surface is

achieved, normally 6-8" from surface

3. Adjust fluid control knob clockwise to

decrease fluid flow

1. Clean air cap

Note: Do not use metal tools to clean

air cap

2. Clean fluid tip

Note: If problem persists after cleaning

replace air cap or fluid tip

1. Check inlet air pressure and

crease if necessary

2. Adjust fluid control knob counter

clockwise to increase fluid flow

3. Thin coating and/or change fluid tip to

next largest size

4. Remove and clean fluid tip

1. Remove and inspect for damage

2. Ensure fluid tip is tight

3. Flush pressure feed with solvent

4. Check/ Refill coating

5. See solution: ( coating leakage out of

rear of spray gun)

1. Reduce inlet air pressure

2. Adjust fluid control knob until desired

results are achieved

3. Ensure proper distance from surface is

achieved , normally 6-8"

Reduce inlet air pressure

Page 17

in-