Agri-Fab 45-02102-101 Owner's Manual - Page 4

Browse online or download pdf Owner's Manual for Spreader Agri-Fab 45-02102-101. Agri-Fab 45-02102-101 16 pages. 125 lb. push broadcast spreader
Also for Agri-Fab 45-02102-101: Owner's Manual (16 pages)

Print Page
ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1)
Pliers
(2)
7/16" Open or Boxed End Wrenches
(3)
9/16" Open or Boxed End Wrenches
1.
Place the spreader upside down.
2.
Assemble the long spacer tube and a 3/4" washer
onto the end of the axle that has the small drilled
hole (right hand side). See Figure 1.
3.
Place the idler wheel (no notch in hub) onto the
axle. The air valve should face to the outside.
See Figure 1.
4.
Assemble one or two more 3/4" washers onto the
axle and then assemble the 1/8" x 1-1/2" cotter
pin. See Figure 1.
SHAFT
SUPPORT
PLATE
SMALL
HOLE
IDLER
WHEEL
1/8" x 1-1/2"
COTTER PIN
FIGURE 1
LONG
SPACER
TUBE
3/4" WASHERS
5.
Place the short spacer tube and a 3/4" washer
onto the end of the axle that has the large drilled
hole (left hand side). See Figure 2.
6.
Place the drive wheel onto the axle. The notched
hub and the air valve should face to the outside.
See Figure 2.
7.
Fasten the wheel to the axle using a 1/4" x 1-3/4"
hex bolt and a 1/4" hex lock nut. See Figure 2.
SHAFT
SUPPORT
PLATE
3/4" WASHER
FIGURE 2
8.
Remove the middle 3/8" hex bolt, flat washer and
hex lock nut from the crossover tube. See figure
3.
CROSSOVER
TUBE
3/8" FLAT
3/8" HEX
WASHER
LOCK NUT
FIGURE 3
4
SHORT
SPACER
TUBE
1/4" x 1-3/4"
HEX BOLT
1/4" HEX
LOCK NUT
DRIVE
WHEEL
3/8" HEX
BOLT
SHAFT
SUPPORT
PLATE