Datatek DT-6061 User Manual - Page 11

Browse online or download pdf User Manual for Computer Hardware Datatek DT-6061. Datatek DT-6061 16 pages. Ip-pad application

Print Page

2.3.10 D

ISPLAYING

URRENT

Syntax: dc

The dc command is used to display all of the current connections into the IP-PAD application.

This includes the X.25 link, and any X.25 virtual circuit connections. The command will issue a

report that shows the connection peer for each active connection.

2.3.11 S

X.25 T

NOOPING

Syntax: snoop [OFF | L2 | <VC#>]

The IP-PAD application has a diagnostic ability to snoop on either X.25 link at the LAPB layer, or

on an individual circuit at the packet layer. This is done with the snoop command. All output is

directed to the OA&M connection.

If the command is invoked with no arguments, it produces a report of all active snooper

configurations.

If the command is invoked with the OFF option, all of the snooper configurations are disabled.

If the command is invoked with the L2 option, the LAPB interface to the X.25 device is snooped.

Output is displayed on the OA&M session. Please note that this could be extensive for a

moderately busy X.25 line.

If the command is invoked with a virtual circuit number in the range of 1 through the maximum

number of X.25 circuits; the packet layer of the circuit specified is snooped.

2.3.12 R

X.25 O

ESTART

Syntax: restart

The restart command is only visible when the application is logged in. The command is used to

manually initiate a protocol restart of the X.25 link and packet layers.

11/01/00

ONNECTIONS

RAFFIC

PERATION

Datatek Applications Inc.