Datatool DT202 Operating Instructions Manual - Page 8
Browse online or download pdf Operating Instructions Manual for Security System Datatool DT202. Datatool DT202 14 pages.
Print PageBike Finder
The Bike Finder feature flashes the directional indicators so that the rider can identify the location
of their motorcycle from afar without disarming the DT202.
Bike Finder is only operational when the DT202 is fully armed and can be activated by pressing
the Programming button on the remote control for 3 seconds. The motorcycle indicators will flash
10 times then stop.
Pressing the Programming button during the directional indicator flashes will cause the flashing to
stop (Note: No need to press and hold).
The DT202 cannot be disarmed whilst the Bike finder Function is operational, triggering the alarm,
during the bike finder flashes will stop the flashes.
Panic Alarm
NOTE: The Panic Alarm does not operate with the ignition ON.
The DT202 offers a 'Panic Alarm' facility that will cause the DT202 siren to sound and the
motorcycle indicators to flash to attract attention. To activate the Panic Alarm, hold down the
Arm/Disarm button on the remote control for 3 seconds with the motorcycle ignition turned
off.
To cease the Panic Alarm, press the Arm/Disarm button on the remote. The Panic Alarm will
run for approximately 5 minutes unless stopped by the remote control.
If the DT202 is disarmed with ignition off, then pressing and holding the Arm/Disarm button
for 3 seconds will first arm the DT202 before triggering the Panic Alarm. If the DT202 is in the
armed state, then pressing and holding the Arm/Disarm button for 3 seconds will disarm the
DT202 before triggering the Panic Alarm feature. If the Arm/Disarm button is pressed a
second time to stop the Panic feature the alarm will always reset to the disarmed state
regardless of the previous state. If the Panic alarm is allowed to complete the 5 minute
duration, then the alarm system will finish in the armed state.
Battery Monitoring
The DT202 monitors the motorcycle battery voltage and, when the DT202 is armed, flashes
the motorcycle instrument LED at a variable rate to notify the measured battery voltage. The
LED flash rate is as follows:
Lead Acid Battery
1
Measured Voltage
Greater or equal to 11.5 V
Between 11.5V and 10.5 V
Less than or equal to 10.5 V
1
Voltages are approximate
2
If the movement sensor is disabled, either by use of Transport Mode or via programming
then the status LED will flash twice in quick succession to indicate that the movement sensor
has been disabled, if the movement has been permanently disabled via programming the
indicators flash three times on arming and if arm/disarm tones are enabled, three chirps will
be heard.
Scorpion House, Drumhead Road, Chorley North Business Park, Chorley, Lancashire, England. PR6 7DE
Tel: +44 (0) 1257 249928 E mail:
2
LED Sequence
Once every 5 seconds
Once every 10 seconds
Once every 20 seconds
Datatool is a brand of Scorpion Automotive Ltd
DT202 Operation Guide Revision 1 24-07-2023
Indicative Status
Fully charged battery
Partially discharged
battery
Low battery
Web: http://www.datatool.co.uk
6