Aussie Pumps MINE BOSS SCUD 351 Operator's Instruction Manual - Page 7
Browse online or download pdf Operator's Instruction Manual for Water Pump Aussie Pumps MINE BOSS SCUD 351. Aussie Pumps MINE BOSS SCUD 351 16 pages.
Also for Aussie Pumps MINE BOSS SCUD 351: Operator's Instruction Manual (16 pages)
Print Page
Jan 2019
B.
Hose Connections
1.
Connect high pressure hose to machine outlet.
2.
If optional low pressure downstream, in-line
chemical injector is to be used, connect the
injector tube to the detergent inlet and place
the other end of the tube, with the strainer
attached, in the chemical container (not
supplied).
3.
Connect gun/lance assembly to high pressure
hose.
4.
Check inlet water filter is clean then connect
water supply hose to machine. Use a 25mm
(minimum) hose .
Incoming water supply must deliver double the
flow of the machine. If questionable, check
supply at machine. If supply is insufficient, do
not operate from this outlet. For residential use,
the outlet closest to the meter will usually
deliver the highest flow rate. Connect only to
clean town water supply.
Warning: Do not operate from tank or pond.
Doing so will cavitate the pump causing
damage. Cavitation or pump starvation is not
covered
by
warranty.
phenomenon causing vacuum pockets to form
within the pump that eventually implode under
pressure pitting the internal pump surfaces.
C.
Before starting the machine
OPERATE IN WELL VENTILATED AREAS ONLY.
1.
Ensure machine is level
2.
Turn on water supply.
3.
Pull gun trigger until water starts to flow in a
steady steam then release trigger.
WORK SMART ... STAY SAFE
D.
1.
2.
3.
4.
5.
6.
Cavitation
is
a
E.
WEAR PROPER FACE PROTECTION WHEN OPERATING
PRESSURE WASHER!
Machine is now ready for operation.
1.
2.
NOTE: Check the system for water leaks, fuel leaks, oil
leaks, hose kinks, etc. Correct any problems before
proceeding.
| Aussie Scud Mine Boss (Class A) ... Operator's Instruction Manual
Starting the engine
Emergency stop button shown reset
Battery isolator
Check the emergency stop button has been
reset.
Turn on battery isolator switch.
Hold the gun trigger on.
Turn key through first to second position.
After engine starts, release the gun trigger.
Warm up engine for 3 minutes without load.
KEEP THE MACHINE OUT OF MOISTURE LADEN
ATMOSPHERES
Pressure washing
For high pressure jetting rotate side grip on dual
lance backwards until it stops. Fine control of
pressure/flow
can
adjustments to the rotation of the grip. There is
no pressure adjustment available on single
lance options.
When low pressure and high flow is required,
including detergent application, unwind grip
two complete turns. Adjust the detergent
control on the pump as required.
Aussie Pumps
Engine start key
be
made
with
small
7