Aussie Pumps Ultra A Operator's Instruction Manual - Page 8
Browse online or download pdf Operator's Instruction Manual for Water Pump Aussie Pumps Ultra A. Aussie Pumps Ultra A 16 pages.
Print Page
Aussie Pumps
HIGH PRESSURE SPRAY CAN PENETRATE
THE SKIN & CAUSE SERIOUS INJURY!
Never point the spray gun at yourself, other people or
animals.
Should the spray penetrate the skin SEEK MEDICAL
ATTENTION IMMEDIATELY!
D.
Starting the engine
(for Honda , refer to engine manual for other engine
options)
Throttle ...
fully open
Choke ... closed position
Fuel value open
1.
Ensure fuel valve is open
2.
Move the choke on the engine to the closed
position. If engine is warm, move choke half-
way.
3.
Turn engine ON/OFF switch to ON
4.
Hold the gun trigger on.
5.
Start engine, either turn engine key or pull the
recoil starter grip lightly until resistance is felt,
then pull briskly.
6.
After engine starts, release the gun trigger and
slowly open the choke.
7.
Warm up engine for 3 minutes without load.
UNLOADER SETTING
The high pressure unloader on the machine
is factory set to operate the pump at it's rated
pressure.
DO NOT ADJUST. Tampering with the unloader will
void warranty and can be dangerous.
WORK SMART ... STAY SAFE
8
WARNING:
CHECK NOZZLES AND REPLACE IF WORN
If pressure drops off, check nozzle for wear. Nozzles
should be replaced on a regular basis (every month for
machines in regular use, every 3 months for machines
used intermittently.
incorrect nozzle size or worn nozzle will void warranty
and can be dangerous to the operator.
KEEP THE MACHINE OUT OF MOISTURE LADEN
E.
Pressure washing
WEAR PROPER FACE PROTECTION WHEN OPERATING
PRESSURE WASHER!
Machine is now ready for operation.
Scud & Ultra A only
1.
2.
NOTE: Check the system for water leaks, fuel leaks, oil
leaks, hose kinks, etc. Correct any problems before
proceeding.
DO NOT RUN EXCESSIVE BY-PASS
SWITCH MACHINE OFF WITHIN TWO MINUTES OF
CEASING OPERATION AS EXCESSIVE BY-PASS CAN CAUSE HEAT
BUILD UP IN PUMP AND SUBSEQUENT DAMAGE.
DEPRESSURISE HOSE BEFORE LEAVING THE MACHINE UNATTENDED
EXCESSIVE BY PASS RUNNING VOIDS WARRANTY!
| Aussie Scud, Ultra A & Predator A ... Operator's Instruction Manual
Using the machine with the
ATMOSPHERES
For high pressure jetting rotate side grip on dual
lance backwards until it stops. Fine control of
pressure/flow
can
be
adjustments to the rotation of the grip. There is
no pressure adjustment available on single
lance options.
When low pressure and high flow is required,
including detergent application, unwind grip
two complete turns. Adjust the detergent
control on the pump as required.
Mar 2021
made
with
small