Aussie Tonneaus ATR01159 Fitting Instruction - Page 4
Browse online or download pdf Fitting Instruction for Automobile Accessories Aussie Tonneaus ATR01159. Aussie Tonneaus ATR01159 4 pages. Tonneau cover to suit flexiglass tray 2350mm x 1805mm
Print Page
2. CARING FOR YOUR TONNEAU
Apply bee's wax or Dri-lube to stitching a few times a year, as this will maintain the tonneau's waterproofing
-
ability and prevent the stitching from degrading. Use a mild detergent and soft scrubbing brush to clean
tonneau.
Never drive without tonneau support bars in place as flapping can cause a delaminating effect on the
-
material.
3. MULTI-FIT SUPPORT BAR
The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from Suburu Brumbys to
Cab Chassis aluminium trays.
3.1 BASIC TOOL REQUIRED
-
Drill, 4mm drill bit
3.2 MULTI-FIT SUPPORT BAR CONTENTS
-
1 x hollow bar centrepiece
-
2 x solid bar end piece
3.3 FITTING MULTI-FIT BAR
1. Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket holders with
the holes facing to the ground (so the grub screws don't rub against the tonneau), as shown above and then
with a white pencil make a mark through the small holes of the hollow bar onto the solid ends. This is where
you will drill a hole to the depth of about 1-2mm (do not go any further)
2. Join the pieces back together and screw grub screws through the hollow bar into the holes that you drilled.
Make sure you do not over tighten the grub screws
give it some extra height to assist with water runoff.
"Tonneau is not designed to be used as a load restraint"
-
2 x grub screws
. Refit the bar. You may kink the bar in the middle to