Agri-Fab 45-0324 Owner's Manual - Page 6
Browse online or download pdf Owner's Manual for Spreader Agri-Fab 45-0324. Agri-Fab 45-0324 12 pages. Atv mounted 125 lb. broadcast spreader
Also for Agri-Fab 45-0324: Owner's Manual (13 pages)
Print Page12. Assemble a seal (turned as shown in fi gure 8) onto the
motor shaft. Slide it up against the motor.
13. Assemble the impeller coupler onto the motor shaft and
secure it with a 1/8" x 1-1/4" cotter pin. Spread the ends
of the pin around the coupler. See fi gure 8.
1/8" x 1-1/4"
COTTER PIN
FIGURE 8
14. Place the screen down into the hopper. DO NOT place
it under the clips in bottom of hopper at this time. See
fi gure 9.
15. Place the motor assembly down into the hopper, inserting
the end of the spreader shaft into the impeller coupler.
Secure it with a 1/8" x 1-1/4" cotter pin, spreading the
ends of the pin around the coupler. See fi gure 9.
16. Fasten the motor mount bracket to the hopper using four
5/16" x 1" hex bolts, 5/16" fl at washers, nylon washers
and 5/16" nylock nuts. See fi gure 9.
MOTOR
ASSEMBLY
5/16" NYLOCK NUT
5/16" FLAT
WASHER
NYLON
WASHER
5/16" x 1"
HEX BOLT
FIGURE 9
17. Lift the screen up and slide the seal down the spreader
18. Slide one edge of the screen under one of the clips.
SEAL
IMPELLER
COUPLER
FIGURE 10
1/8" x 1-1/4"
COTTER PIN
SPREADER
SHAFT
SCREEN
6
shaft to rest against the plastic bushing in the bottom
of the hopper. See fi gure 10.
Then, slightly bow the screen to slide the opposite side
of the screen under the other clip. See fi gure 10.
CLIP
SCREEN
CLIPS
SHAFT
SEAL
BUSHING