Dateq LPM 7.3 User Manual - Page 6

Browse online or download pdf User Manual for DJ Equipment Dateq LPM 7.3. Dateq LPM 7.3 13 pages.

Print Page

Dateq LPM 7.3 Manual

Connections

BALANCED

MASTER L / R

MASTER

MON

PFL

REC

EFFECT SEND

EFFECT RETURN

CHANNELS 1..7

CUE

FUSE

MAINS

Electronically balanced master outputs for the left and right channel on

XLR connectors. This type of output guarantees a perfect signal transport

even when long audio cables are being used. These outputs are equipped

with relays to prevent audible 'blobs' on connected equipment when the

LPM 7.3 is switched on or off.

Unbalanced master output on cinch-connectors. Can be used to connect

the LPM 7.3 to an amplifier or a recorder.

Unbalanced monitor output on cinch connectors. Can be used to connect a

second amplifier with monitor speakers for the DJ or a second room.

Unbalanced output on cinch connectors. This output follows the pre-fader

listening. This output can be used to connect an (monitor) amplifier or

recorder.

Unbalanced recorder output on cinch-connectors. This output is fixed-level

(independent from the master volume control).

Stereo postfader effect sends from microphone inputs. This output can also

be used as a cleanfeed output.

Stereo effect return input. Can also be used as an extra input.

Cinch connectors for all stereo channels. Channel 1, 2, 6 and 7 have two

identical line inputs. Channels 3, 4 and 5 have both an input for turntables

(phono) and an input for equipment like CD-players, samplers, keyboards

and recorders (line). When turntables are being used, these must be

earthen by means of the earth-clamp.

Electronically balanced microphone input on XLR connector. When used

unbalanced, connect pin 1 and 3 with the shielding of the cable. Both

channels are equipped with a secondary stereo line input.

Channel 3, 4 and 5 are equipped with a remote start connector. As soon as

the fader of the concerning channel is opened, the contact between tip and

ring of this mini jack (3,5 mm) connection is made. With this the connected

equipment can be remote started. The remote-connection is NOT suitable

for switching mains voltage!

Mains fuse. Dimension 5x20mm (small), 315mA slow.

Euro-style mains inlet. Before connecting the LPM 7.3for the fist time,

check if your LPM 7.3 is meant for the mains voltage in your country (label

on the connector board at the rear).

For all cinch-connectors:

White = Left, Red = Right.

Connections