Datum DTR30G Operating Instructions Manual - Page 14

Browse online or download pdf Operating Instructions Manual for Laser Level Datum DTR30G. Datum DTR30G 16 pages. Rotary laser dual grade

Print Page

TROUBLESHOOTING

ISSUE

Laser does not turn on

Laser does not level

Laser beam distance is reduced

Laser head does not rotate

Laser detector is not working

properly

PRODUCT LABELS

50mm

DTR30R

CAUTION: LASER RADIATION

DO NOT STARE INTO BEAM

CLASS 2 LASER PRODUCT

ACCORDING TO IEC/EN 60825-1:2014

MAXIMUM POWER OUTPUT < 1mW @ 635nm

Battery: 4 x 1.5V C-Cell

Ni-MH 4 x 1.2V 4000mAh

Part #: DTR30R

DATUM - 20 THACKRAY ROAD PORT MELBOURNE VIC 3207

POSSIBLE CAUSE AND SOLUTIONS

Check batteries. Make sure batteries are installed according to the

correct polarity.

The batteries may be low or depleted. Make sure the batteries are in

proper working condition. If in doubt, try installing new batteries.

If the laser has been stored in extremely hot temperatures, allow it to

cool.

Instrument may be outside it's levelling range. Position the

instrument, tripod or the base surface.

Instrument may have impact damage. Contact service centre for

repair and calibration.

Instrument may be outside its self-levelling range. Adjust the position

within the self-levelling range.

Instrument may be in Manual Mode. The laser must be in Automatic

Mode to self level.

Dirt and dusty condition can reduce the visibility of the laser beam.

Clean the laser output window.

Instrument may be levelling or in Wind Mode. Refer to "Direction of

Use".

The detector may be low in battery. Replace batteries and install

according to the correct polarity.

The detector may be out of usable range. Move the detector closer to

the instrument.

ROTARY

60mm

LASER

MADE

IN CHINA

50mm

DTR30G

CAUTION: LASER RADIATION

AVOID DIRECT EYE EXPOSURE

CLASS 3R LASER PRODUCT