AUSTRALIAN MONITOR PAGENET 88 Operating Manual - Page 5

Browse online or download pdf Operating Manual for Accessories AUSTRALIAN MONITOR PAGENET 88. AUSTRALIAN MONITOR PAGENET 88 8 pages. Installation series zone paging system
Also for AUSTRALIAN MONITOR PAGENET 88: Brochure (2 pages)

Print Page

Zone Inputs

The matrix includes 8 zone inputs. In other words, the audio from each of the PN88M zone microphones. Each of these

balanced XLR inputs is line level. While other line level sources could be plugged into these inputs, the only way to

direct them to go anywhere is via a PageNet mic console. Much of the switching logic for the system is included in the

zone microphone which, apart from pre-amping the signal from mic to line level, also tells the system where each input

is to be sent. In summary, these inputs are really only designed for PageNet zone mics. Please note that the audio from

each mic must be wired back to the matrix.

Program Inputs

4 program source inputs are provided. Each input features dual RCA inputs and is suitable for a variety of sources

including Tape decks, CD players, digital message players and wireless mics with line outputs.

Program Input Trim Controls

A recessed trim (gain) pot is provided for each of the 4 program source inputs. The trim pots are provided so that each

source can be matched in level so that the volume is consistent when a user switches between program sources in a

zone.

The following adjustments involve access to the inside of the PageNet matrix. This should only be attempted by a

qualified technician. Always turn off the AC power and remove the AC power cord before attempting to access the

inside of the unit.

Pre-Announce Chime Defeat:

chime is activated automatically when a zone is paged. The Pre-Announce chime can be defeated for any or all zones by

moving an internal jumper (for each zone). A pre-announce on/off jumper for each zone can be found on the main board

behind the Zone Input XLR's.

Pre-Announce Level Control:

pre-announce level in all 8 zones. The pot is labeled 'R70' and can be found on the main board behind the Zone Input

XLR's.

Alert and Evac Tone Level Control:

behind the Program Input RCA's. It adjusts the level of both the Alert and Evac tones.

Sum Level Trim:

The Sum level trim pot, labeled R72', can be found on the main board behind the Program Input

RCA's. It adjusts the level of the sum input (rear panel Phoenix connector).

Wiring of the 15 pin 'D' connector is simply Pin 1 to 1, 2 to 2, 3 to 3 etc connecting all 15 pins. The shield should be

soldered to the connector case at both ends. Connectors and cable not supplied with the system.

Cable Type (Logic):

Cable Type (XLR)

Connector (Logic):

Connector (XLR):

Other Internal Adjustments

The PageNet system ships with an active pre-announce chime meaning that a

This pot adjusts the level of the Pre-Announce chime. The one pots affects the

The Evac/Alert trim pot, labeled 'R71', can be found on the main board

Wiring and Connector Information

Hartland HCE316 or equivalent

Twin core shielded microphone cable (eg AMIS S2C122B, MC6030 or ATC8000)

Standard (not high density) 15 pin 'D' Connector, both male and female required (all cables-

male to female)

3 pin female XLR required to mate with Zone Mic

3 pin male XLR required to connect Zone Mics to Matrix

3 pin female XLR required to mate with Zone Outputs