Agri-Fab 45-0355-131 Owner's Manual - Page 4

Browse online or download pdf Owner's Manual for Tiller Agri-Fab 45-0355-131. Agri-Fab 45-0355-131 8 pages. 3 pt. hitch tang cultivator
Also for Agri-Fab 45-0355-131: Owner's Manual (8 pages)

Print Page

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983

ASSEMBLY

TOOLS REQUIRED FOR ASSEMBLY

(2) 3/4" Wrenches

(2) 9/16" Wrenches

(2) 1-1/8" Wrenches or Adjustable Wrenches

(1) 1-5/16" Wrench or 12" Adjustable Wrench

CAUTION: THE CULTIVATOR TANGS

HAVE SHARP POINTS. USE CARE

WHEN HANDLING AND ASSEMBLING

THE TANGS. WEAR GLOVES FOR

EXTRA PROTECTION AGAINST CUTS.

Remove all loose parts and the hardware package

from the shipping carton. Lay out and identify each

part and the hardware as shown on pages 2 and 3. Be

sure the carton is empty before it is discarded.

1. Attach two depth gauge bars to the frame using a

3/8" U-bolt and two 3/8" Nylock hex nuts for each

bar. Put each depth gauge bar next to each out-

side tang on the rear of the frame as shown in

figure 1. Use the holes in each bar that will give the

desired working depth, if known at this time. Use

matching holes in both depth gauge bars to keep

the cultivator level.

NOTE: For effective depth control a depth gauge bar

must not be located directly behind a front tang.

3/8"

U-BOLT

DEPTH

GAUGE BAR

FIGURE 1

2. Attach two mast extension straps to the front of

FIGURE 2

3. Attach the cross brace and the two mast sides to

DEPTH

GAUGE

BAR

WORKING

DEPTH

3/8" NYLOCK

HEX NUT

FIGURE 3

www.mymowerparts.com

the frame using two 1/2" x 2-3/4" hex bolts and two

1/2" Nylock hex nuts. Point the bent end of each

strap toward the outside of the frame. Do not

tighten yet. See figure 2.

1/2" NYLOCK

HEX NUT

FRONT

MAST EXTENSION

STRAP (RIGHT

SIDE)

the ends of the mast extension straps. The cross

brace is between the extension straps while the

mast sides are on the outside. The cross brace

and mast sides are connected to the extension

straps using two category 1 pins, two 7/8" lock

washers, and two 7/8" hex nuts. Do not tighten

yet. See figure 3.

7/8" LOCK WASHER

7/8" HEX

NUT

CROSS

BRACE