AUTEC Air series Original Instructions Manual - Page 9

Browse online or download pdf Original Instructions Manual for Remote Control AUTEC Air series. AUTEC Air series 16 pages. Receiving unit
Also for AUTEC Air series: Manual (8 pages), Manual (13 pages), Instruction Manual For The Use And The Maintenance (20 pages), Manual (12 pages), Instruction Manual For The Use And The Maintenance (20 pages), Original Instructions Manual (8 pages), Original Instructions Manual (8 pages), Manual (8 pages), Original Instructions Manual (8 pages)

AUTEC Air series Original Instructions Manual
General operating instructions
6.4

Radio link interruption

When the radio link is incorrect or interrupted, the receiving unit autonomously stops the
radio remote control.
The green LED on the transmitting unit switches from blinking slowly to fast blinking or
steady on.
Press the START pushbutton to start the radio remote control.
6.5

Transmitting unit automatic switch off

The transmitting unit automatically switches off when:
- the battery is flat (see paragraph 6.5.1)
- the radio remote control is not used for a certain time (see paragraph 6.5.2)
Press the START pushbutton to start the radio remote control.
6.5.1
Low battery
The transmitting unit indicates if the battery is not sufficiently charged (the red LED blinks fast).
- The red LED blinks slowly (one blink per second): the battery has a 2 hour run time from
the first signal.
- the red LED blinks fast: the battery has a 10 minute run time from the first signal, after
which the transmitting unit automatically switches off.
The battery needs to be replaced with a charged one (see paragraph 7.1).
6.5.2
When the transmitting unit is not used
If the transmitting units remains started with no enabled commands, it will automatically
switch off after a predetermined time frame.This time frame is provided in the technical data
sheet (SWITCH-OFF).
Before the transmitting unit switches off automatically, the green and red LEDs blink alternating
for 30 seconds.
6.6

Switching off the transmitting unit

The transmitting unit shall be switched off each time work is stopped: remove the Air-KEY
(see paragraph 7.2.2) and always store it in a safe place.
AUTEC - Air series
9
LIAJSE00-00