AUTEC Air series Original Instructions Manual - Page 14

Browse online or download pdf Original Instructions Manual for Receiver AUTEC Air series. AUTEC Air series 16 pages. Receiving unit
Also for AUTEC Air series: Manual (8 pages), Manual (13 pages), Instruction Manual For The Use And The Maintenance (20 pages), Manual (12 pages), Instruction Manual For The Use And The Maintenance (20 pages), Original Instructions Manual (8 pages), Original Instructions Manual (8 pages), Manual (8 pages), Original Instructions Manual (8 pages)

Print Page
AUTEC Air series Original Instructions Manual
14
8

Malfunction signalled by the transmitting unit

Use the light signals on the transmitting unit to identify the radio remote control malfunction.
If the problem persists after the suggested solution has been carried out, contact the support
service of the machine manufacturer.
Signals
The green LED is steady
on.
The green LED blinks
fast.
The green LED blinks
slowly
(one blink per second).
The red LED is steady
on during start up
The red LED blinks
twice per second during
start up.
The red LED blinks
three times per second
during start up.
The green and red LEDs
are steady on and an
acoustic signal sounds
during start up.
LIAJSE00-00
Possible reason
The transmitting and
receiving unit do not
communicate.
The radio remote control
is not started up.
The receiving unit may
not work correctly.
The STOP pushbutton is
activated or damaged.
At least one of the
commands that were
checked at start-up (see
technical data sheet) is
enabled or damaged.
The battery is flat.
The Air-KEY was
inserted in an incorrect
transmitting unit.
The transmitting unit
has been replaced and
the Air-KEY has been
inserted in the "BACK-UP
UNIT" transmitting unit.
Malfunction signalled by the transmitting unit
Solutions
Start up the radio remote control. If the
radio remote control does not start up,
check that the receiving unit is powered
on.
Bring the actuators corresponding
to movement commands to the
rest position and press the START
pushbutton until the green LED blinks
slowly.
See "Receiving unit signals" in Part D.
Unlock the STOP pushbutton or contact
the support service.
Bring the actuators corresponding to the
commands checked during start up to
the rest position or contact the support
service.
Replace the battery with a charged one.
Use the correct transmitting unit.
Store the address in the "BACK-UP
UNIT" (see paragraph 7.2.3).
AUTEC - Air series