Airwell RC08A Manual - Page 4

Browse online or download pdf Manual for Remote Control Airwell RC08A. Airwell RC08A 7 pages.

Print Page

OPERATIION

COOLING

Verify that the unit is connected to the main

power and the STANDBY lamp is lighted up.

1. Set the MODE selector to COOL

2. Press the ON/OFF (

) button and switch the

airconditioner ON.

3. Press the - or +. buttons to set the desired

temperature The temperature range is between

16℃ and 30℃(61-86 F).

THE DISPLAY SHOWS THE

SELECTED TEMPERATURE..

4. Press the FAN SPEED button to select the fan

speed.

HEATING

1. Set the MODE selector to HEAT

2. Press the ON/OFF

(

)

button and switch the air condioner ON.

3. Press the + or -. buttons to set the desired temperature, the temperature range is

between 16℃ and 30℃(61-86F).

4. Press the FAN SPEED button to select the fan speed.

THE DISPLAY SHOWS THE

SELECTED TEMPERATURE..

NOTE

For several minutes after the start of heating operation, the indoor fan will not run until

the indoor heat exchanger coil has warmed up sufficiently. This is because the COLD

DRAFT PREVENTION SYSTEM is operating.

DEFROSTING OF HEAT EXCHANGE / OUTDOOR UNIT "STANDBY"

When the outdoor temperature is low, frost or ice may appear on the heat

exchanger

coil,reducing the

heating performance.

microcomputer defrosting system operates. At the same time, the fan in the

indoor unit stops until defrosting is completed. Heating operation restarts after

several minutes. (This interval will vary slightly depending on the room and

outdoor temperature).

HEATING PERFORMANCE

A heat pump air conditioner heats a room by taking heat from outside air. The

heating efficiency will reduce when the outdoor temperature is very low.

AUTOMATIC OPERATION

1. Set the MODE selector to AUTO

2. Press the ON/OFF (

) button and switch the air conditioner ON.

3. Press the + or -. buttons to set the desired temperature (The temperature range is

between 16℃ and 30℃(61-86F).

THE DISPLAY SHOWS THE

SELECTED TEMPERATURE.

When this setting is selected, the air conditioner calculates the difference between the

thermostat setting and the room temperature and automatically switches to the COOL,

DRY or HEAT mode as appropriate.

4. Switch the FAN SPEED selector button to the setting you want.

OPERATIION

When

this happens,