Airwell RC5 Manual - Page 4

Browse online or download pdf Manual for Remote Control Airwell RC5. Airwell RC5 8 pages. For room air conditioner
Also for Airwell RC5: Programming And Operations Manual (11 pages)

Print Page

OPERATION

HOW TO SET THE PRESENT TIME

1. Press the SET button for five seconds. The

time indication alone flashes.

2. Press the + or - buttons until the present time

is displayed.

3. Press the SET button to stop the indication

flashing.

COOLING

Ve r i f y t h a t t h e u n i t i s

connected to the main

power and the STANDBY

lamp is light up.

1. Set the MODE selector

to COOL

2 . P r e s s t h e O N / O F F

button and switch the

airconditioner ON.

3 . P r e s s t h e T E M P.

b u t t o n s t o s e t t h e

desired temperature

(the temperature range

is between 30°C max.

and 16°C min.).

THE DISPLAY SHOWS THE

SELECTED TEMPERATURE.

4. Press the FAN SPEED button to select the fan

speed.

5. Press button

swing. By pressing this button

can stop the auto swing and position the air

flap at any desired angle.

HEATING

1. Set the MODE selector to HEAT

2. Press the ON/OFF button and switch the air

condioner ON.

3. Press the TEMP. buttons to set the desired

temperature (the temperature range is

between 30 °C max. and 16 °C min.).

THE DISPLAY SHOWS THE

SELECTED TEMPERATURE.

to activate the auto air

again, you

4. Press the FAN SPEED button to select the fan

speed.

5. Press button

swing. By pressing this button

can stop the auto swing and position the air

flap at any desired angle.

NOTE

For several minutes after the start of heating

operation, the indoor fan will not run until the

indoor heat exchanger coil has warmed up

sufficiently. This is because the COLD DRAFT

PREVENTION SYSTEM is operating.

DEFROSTING OF HEAT EXCHANGE OUT

DOOR UNIT "STANDBY"

When the outdoor temperature is low, frost or

ice may appear on the heat exchanger coil,

reducing the heating performance. When this

happens, a microcomputer defrosting system

operates. At the same time, the fan in the indoor

unit stops and the OPERATION lamp is flashing

until defrosting is completed. Heating operation

restarts after several minutes. (This interval will

vary slightly depending on the room and outdoor

temperature).

HEATING PERFORMANCE

A heat pump conditioner heats a room by taking

heat from outside air. The heating efficiency will

fall off when the outdoor temperature is very

low. If enough heat is not obtained with this air

conditioner, use another heating appliance in

conjunction with it.

to activate the auto air

again, you