Benedini TBS Mini Technical Data Manual - Page 9
Browse online or download pdf Technical Data Manual for Control Unit Benedini TBS Mini. Benedini TBS Mini 11 pages. Digital multifunctional rc-soundunit
Also for Benedini TBS Mini: Manual (11 pages), Manual (11 pages)
Print Page
3.4. Autostart
If you are interested only in an engine sound the "autostart" mode can be used. The engine starts
automatically at the first short acceleration.
If the engine is more than 20s idle, it shuts down automatically.
There is no extra control channel necessary.
No special sounds can be played in this mode and NO switching outputs can be used !!!!
Teaching the autostart mode:
NOTE: During the programing sequence:
After you move the throttle stick from the last stored position a very short beep is played. You
have about 2 seconds to move to the new throttle stick position to be stored next.
1) Power on the transmitter and receiver. The sound unit LED blinks fast = normal mode.
Bring the throttle stick to minimum.
2) Press the LEARN button until one beep occurs = the LED is continuously lit.
At this step all neutral / idle positions are stored.
3) Move the throttle stick to your desired acceleration point and wait for a Beep.
4) Move throttle stick to full throttle and wait for three Beeps.
The Sound unit will revert to operational mode after a short time.
4. Changing the control mode
It is possible to change the set control mode without the optional USB programing cable:
1. Press the programing button DURING powering on the sound unit.
2. Release the button.
3. Press the prog. button momentarily and you will hear a "Beep-Code".
4. Repeat pressing the button until the desired control mode is signalized by the according
"Beep-Code".
5. Switch the sound module off and on again.
„Beep-Code"
1 x Beep
->
2 x Beep
->
3 x Beep
->
Note:
If the control mode "autostart" is selected, there is no control channel defined.
If you want to switch from autostart to another control mode you need to program a control
channel by using TBflash and the optional programming cable!
5. Connecting an external amplifier
If you want to connect an external amplifier, other than a Benedini one, please follow this
schematic:
TBS Mini speaker plug
Spkr Minus
TBS Mini
Autostart
Toggle switch
12 position encoder
Watch the ground connection !!!!
Spkr Plus
Gnd
www.benedini.de
Volume Pot: 220 Ohm
Throttle
Audio to the
Amplifier
Page 9 of 11