Dymo KeepnTrack Installation Manual - Page 3

Browse online or download pdf Installation Manual for Software Dymo KeepnTrack. Dymo KeepnTrack 16 pages. Badge printer

Print Page

• Following the directions listed on the inside of the printer, load the labels onto the

spool with the labels feeding from below, making sure that the roll is positioned

tightly on the spool with no gap between the roll and the spool.

• Feed the labels into the printer, aligning the labels with the left wall of the printer

and against the label guide, and press the form-feed button on the front of the

printer.

• Gently close the lid.

• An error light will blink if paper nears its end or is incorrectly installed.

Solid Blue - Power is ON and printer is ready

Dimmed Blue - Printer is in power-saving mode

Flashing Blue - Labels are not loaded properly or the label roll is empty

NOTE: LABELS ARE HEAT SENSITIVE! DO NOT EXPOSE TO HEAT, DIRECT

SUNLIGHT, OR MOISTURE WHILE STORING.

Summary of Installation Steps

In order to use your badge printer with KeepnTrack, you must ﬁrst properly install

the hardware and device drivers before conﬁguring the printer software:

1. On your computer, install the required printer software and then plug in the

printer.

NOTE: DO NOT PLUG THE PRINTER INTO THE COMPUTER UNLESS PROMPTED BY THE

SOFTWARE OR THE INSTALLATION PROCESS IS COMPLETE.

2. Conﬁgure the KeepnTrack Administration Settings to use a badge printer.

3. Finally, conﬁgure the KeepnTrack Kiosk to use your printer.

These steps will be covered comprehensively below.

Installing the Printer Software on Windows

Before using your badge printer, you must ﬁrst install the printer software. The

software can be found on the installation CD provided. Locate and Run the ﬁle

labeled DLS8Setup.8.x.x.exe (Image 1).

NOTE: THE SOFTWARE COMPONENTS MAY ALSO BE DOWNLOADED FROM:

http://www.keepntrack.com/support_downloads.html

IG0080.8 - v6010 Badge Printer!