Gadget Labs WAVE/4 User Manual - Page 5

Browse online or download pdf User Manual for Sound Card Gadget Labs WAVE/4. Gadget Labs WAVE/4 20 pages. 4 channel pc digital audio card

Print Page

Choose: 'Driver from disk provided by hardware manufacture'

Make sure that 'Copy Manufacturer's files from:' shows, 'A:\'

Insert the Wave/4 Drivers Disk, and click OK

The driver files will be copied and the system automatically

setup to use the Wave/4 card

Connecting audio & MIDI

to the external connector

Here's the connector layout

from top to bottom è

For audio, all connectors

are standard line level,

stereo left + right.

NOTE:

Microphones do not

have enough signal strength and

must be amplified by a mixer or

preamplifier prior to connecting

to the Wave/4 card.

Connecting a wavetable synthesizer daughter card to the Wave/4

The Wave/4 card includes a special, 26 pin connector (13 x 2) for adding a

wavetable synthesizer "daughter" card.

several manufacturers. Due to mechanical constraints, the Wave/4 card will

accommodate a reduced-size, mini wavetable card, but a full-sized card will

NOT fit. For example, the Yamaha DB50XG wavetable card will NOT fit on

the Wave/4 card, but the Kurzweil synth wavetable card from Gadget Labs

will fit fine. Contact us if you have any questions or need assistance in

locating an appropriate wavetable card.

Before installation

Wave/4 card

Daughter card

connector

Installing the daughter card

1. Turn off your computer and open the case.

2. Remove the Wave/4 card from your computer.

3. Locate the 26-pin interface connector JP2 on the Wave/4 card.

4. Orient the daughter card with respect to the Wave/4 card as shown in the diagram.

Center the card connector on the pins. Carefully push the daughter card until it is

firmly seated. All 26 pins should be seated in the daughter card connector.

Channel 1 (Ch1), audio IN (stereo)

Channel 2 (Ch2), audio IN (stereo)

Channel 1 (Ch1), audio OUT (stereo)

Channel 2 (Ch2), audio OUT (stereo)

audio OUT from Wavetable synth card (stereo)

MIDI adapter with DIN connectors. The DIN

connectors are labeled In, Out and Thru

These cards are available from

After installation

IMPORTANT !

Make sure that all pins are

seated in the daughter card

connector.

If any pins are

showing on either side of the

connector, it is seated incor-

rectly.

If this occurs, gently

remove the daughter card by

pulling it straight up from the

Wave/4 card and repeat Step 4

below.

Failure to correctly

install the daughter card WILL

result in damage to the daugh-

ter card when you turn on your

computer.