GRDIAN Charger Plus User Manual - Page 13

Browse online or download pdf User Manual for Test Equipment GRDIAN Charger Plus. GRDIAN Charger Plus 18 pages. Hardwire kit

Print Page

TEST THE CONNECTION

Your vehicle's electrical system should be completely OFF.

setting your voltage setting to the lowest value (11.6V/23.6V).

1. Connect the Cigarette Socket to the OUTPUT terminal of the Charger Plus.

2. Connect the Component Wires to the INPUT terminal of the Charger Plus.

3. Once connected, the Charger Plus should turn on. A

4. Turn on your vehicle's electrical system. If installed correctly, the Charger Plus should turn

on and the indicator should turn GREEN.

5. Insert your cigarette charger into the Cigarette Socket. Tape down to make sure it is secure.

NOTE: If the Charger Plus is not green, make sure you installed your Charger Plus correctly.

Remove the Input Connection, make sure your vehicle's electrical system is completely OFF.

Re-establish connection by re-inserting the Input Connection and turning your vehicle's electri-

cal system ON.

CHECKLIST

Make sure you are using a Constant and Switched Fuse. Refer to Step 3.

Make sure the BATT+ (YELLOW) wire is connected to the Constant fuse slot. Refer to Step 6.

Make sure the ACC+

Make sure your GND wire is properly connected to a ground point. Refer to Step 2 and 6.

Make sure your add-a-fuse is correctly inserted in the right direction. Refer to Step 4.

Remove the Input Connection. Make sure your vehicle's electrical system is completely OFF.

Insert the Input Connection back in, and turn on your vehicle to test.

STEP 7: TEST THE CONNECTION

wire is connected to the Switched fuse slot. Refer to Step 6.

(RED)

Before connecting, we recommend

RED

indicator should light up.