5five F26R User Manual - Page 11
Browse online or download pdf User Manual for Car Receiver 5five F26R. 5five F26R 20 pages. Car aux /usb/microsd receiver with bt function
B A S I C O P E R A T I O N S A N D
R E C E I V E R O P E R A T I O N M O D E S
Turn on / off the player
Press the power button on the front panel to turn on the head unit. To turn
off the receiver, in any mode, press and hold the button for 3 seconds.
To select a mode, you can sequentially press the button
panel. The modes are displayed in the following sequence: RADIO / USB / SD
/ AUX / BT. USB and SD memory card modes are available only if the
appropriate drive is inserted in the slot of this unit
Volume control
The desired volume level is set by rotating the encoder on the front panel of
the receiver.
Mute
To block the sound instantly, press the MUTE button on the front panel. To
return to the previous sound level, press the MUTE button again.
Sound setting
Press on the encoder to select a custom parameter:
VOL / BAS / TRE / BAL / FAD / LOUD OFF / EQ OFF / STEREO / DX.
· BASS * Adjusts the bass tone.
· TREBLE * Adjusts the treble tone.
· BALANCE Adjusts the balance between the right and left speakers.
· FADER Adjusts the balance between the front and rear speakers.
· LOUD Off/On Turns the loudness mode on / off.
· EQ Off/On Turns the equalizer on / off.
Rotate the encoder to select one of the five settings:
POP / ROCK / JAZZ / CLASSIC / COUNT
equalizer settings.
· STEREO / MONO, switch between modes.
· DX / LOC switch between receive all radio stations / receive radio stations
with the strongest signal.
When setting, the selection of parameters is carried out by rotating the
encoder. After this, do not take any action for 3 seconds to save your
settings.
Note: * Bass and treble adjustments are available only when the equalizer is
off (EQ OFF mode)
EQ settings
Press the volume control repeatedly to select the equalizer setting mode
EQ. By turning the encoder, you can select one of four modes for adjusting
the equalizer: POP / ROCK / JAZZ / CLASSIC / COUNT. Or you can just use
button EQ.
on the front
11