Active Products ZE02 Manual - Page 6

Browse online or download pdf Manual for Pressure Washer Active Products ZE02. Active Products ZE02 18 pages.

Print Page

ASSEMBLY AND OPERTATING INSTRUCTIONS

Assembly Time: 2 minutes / Tools Required: None

Surface Preparation

Before starting any cleaning task, it is important to inspect the area for objects which could create a hazard.

Remove from the workarea which could be tripped over, such as toys or outdoor furniture. Ensure that all

doors and windows are closed tight.

CAUTION

• Never use the pressure washer to draw

in water contaminated with solvents (e.g.

paint thinners, gasoline, oil, etc.).

• Dirt in the feed water will damage the unit.

To avoid this risk, we recommend checking

the water filter (located inside the water

inlet; to clean it out see Maintenance sec-

tion on page 11).

• Always prevent debris from being drawn

into the unit by using a clean water source

and an accessory water filter if required.

Fig. 1

Step 1

Make sure that the ON/OFF switch is in the

"OFF" position.

Fig. 3

Step 3

Insert the wand into spray gun, and twist 1/4 turn until rectangular tab appears.

Water Supply (Cold Water Only):

• Do not draw non-water liquids through the unit. For

use with cold water supply only.

• Water hose must be at least a 1/2 inch diameter.

• Flow rate of water supply must not fall below 2

GPM (gallons per minute).

• Flow rate can be determined by running the water

for one minute into an empty 5-gallon container.

• The water supply temperature must not exceed

104°F (40°C).

CAUTION

To prolong the life of the unit, it is recom-

mended to rest the unit 5 minutes after

every 30 minutes of use.

Fig. 2

Step 2

Separate the adaptor and quick-connect coupling.

Attach inlet adaptor to the machine's inlet and attach

the quick-connect coupling onto the garden hose.