HHC CH11HHC001 Instructions - Page 3

Browse online or download pdf Instructions for Control Unit HHC CH11HHC001. HHC CH11HHC001 3 pages. Hand control

Print Page

5. Matters needing attention：

5.1 Do not mix old and new batteries or different types of batteries in remote.

5.2 When the battery power is weak, electrolyte leakage may occur, and will damage the

remote. Once the power is low, replace the battery as soon as possible.

5.3 If the remote will not be used for a long period of time, remove the batteries to avoid

electrolyte leakage.

5.4 The battery should not be exposed to direct sunlight, fire, or other excessive heat. To

protect the environment, used batteries should be recycled in a proper manner.

6. Additional attention for user：

6.1 This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/ TV technician for help.

6.2 This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

6.3 This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. End users must follow the specific operating instructions for satisfying RF exposure

compliance. To maintain compliance with FCC RF exposure compliance requirements, please

using a minimum separation distance of 5 mm from the device.

This transmitter must not be co‐located or operating in conjunction with any other antenna

or transmitter.

6.4 For Intentional and unintentional radiators the manual shall caution the user that changes

or modifications not expressly approved by the party responsible for compliance could void the

users authority to operate the equipment

3/4