HHP Imageteam 3800LTP Quick Start Manual - Page 2

Browse online or download pdf Quick Start Manual for Laboratory Equipment HHP Imageteam 3800LTP. HHP Imageteam 3800LTP 12 pages. Hand held linear imager

Print Page

Agency Compliance Statements

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired

operation.

FCC Class B Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

•

Consult the dealer or an experienced radio or television technician for help.

Caution: Any changes or modifications made to this device that are not expressly approved

by Hand Held Products, Inc. may void the user's authority to operate the equipment.

Note:

To maintain compliance with FCC Rules and Regulations, cables connected to this

device must be shielded cables, in which the cable shield wire(s) have been

grounded (tied) to the connector shell.

Canadian Notice

This equipment does not exceed the Class B limits for radio noise emissions as described

in the Radio Interference Regulations of the Canadian Department of Communications.

Le present appareil numerique n'emet pas de bruits radioelectriques depassant les limites

applicables aux appareils numeriques de la classe B prescrites dans le Reglement sur le

brouillage radioelectrique edicte par le ministere des Communications du Canada.

The CE mark on the product indicates that the system has been tested to and

conforms with the provisions noted within the 89/336/EEC Electromagnetic

Compatibility Directive and the 73/23/EEC Low Voltage Directive.

For further information please contact:

Hand Held Products, Inc.

Nijverheidsweg 9

5627 BT Eindhoven

The Netherlands

HHP shall not be liable for use of our product with equipment (i.e., power supplies, personal

computers, etc.) that is not CE marked and does not comply with the Low Voltage Directive.

LED Safety Statement

This device has been tested in accordance with EN60825-1 LED safety, and has been

certified to be under the limits of a Class 1 LED device.

TÜV Statement

TÜV or GS marked to EN60950 and EN60825-1.

C-Tick Statement

Conforms to AS/NZS 3548. C-Tick number: N10410.