GRE CV790205 Assembly Manual

Browse online or download pdf Assembly Manual for Lighting Equipment GRE CV790205. GRE CV790205 7 pages. Isothermal covers

Print Page

ASSEMBLY SUGGESTIONS: ISOTHERMAL COVERS

Suggestions for correct positioning: / Installation suggestion

Place the surface with air bubbles of the cover in contact with the surface of the water,

leaving the at surface of the cover visible

To assure a long life of the cover, it is necessary / obligatory to remove it from the pool.

- When the temperature of the water reaches 30 degrees Celsius.

- At that time and during the next 48 hours, perform the shock chlorination.

(The chlorine content should not exceed 1 PPM)

After having removed the cover from the pool, (we strongly recommend using a swimming pool

roller):

- It must be protected against solar radiation.

- If you do not have a rolling device, it is recommended to fold it in several places or roll it on

itself to keep it protected from sunlight.

You should never leave the cover inside the pool during winter.

- It should be rinsed with clean water, dried and stored in a place protected from ice and sunrays.

Stability of the dimensions:

- A 1 to 2% variation of the cover is possible. We are not responsible for variations equal to or

lower than 5cm.

Avoid contact with sharp or abrasive edges, because these can cause wear by friction, tears or

cracks as well as removal of the colour, which are not covered by guarantee

You should carefully follow the pre-

vious suggestions to have the bene t

of the guarantee.

Maintenance suggestions

Flat surface

facing up

Bubble surface

facing down

Contents of packet:

- The bubble cover guarantees the season

When using the tarpaulin, shield it from

sunlight