Gage Bilt GB108A/2 Original Instructions Manual - Page 10

Browse online or download pdf Original Instructions Manual for Tools Gage Bilt GB108A/2. Gage Bilt GB108A/2 17 pages. 20v battery installation tool

Print Page

Additional Actuator Assy (VP1316) functions:

Note: The installation tool has two additional functions that are controlled with the actuator assy (VP1316).

Service position: Press the actuator assy (VP1316) for five seconds (until the white LED on the tool starts to flash (1 /sec) and

release again. The installation tool remains in the rearmost position. The anvil insert can now be easily changed or the clamping

jaws serviced. Press the actuator assy (VP1316) briefly and the tool moves to its starting position again.

Auto and Manual mode:

a. In Manual mode, hold the actuator assy (VP1316) depressing during setting of the fastener until the mandrel is

sheared off.

b. In Auto mode, you only have to press the actuator assy (VP1316) briefly and the installation tool controls the

fastening

To change from one mode to the other, hold the actuator assy (VP1316) pressed for ten seconds (until the white LED on the

tool starts

to flash (2 sec.) and release again. Press the actuator assy (VP1316) briefly and the tool moves to its starting

Attaching the Belt Clip (VP1322):

position again.

Note: Always ensure belt clip (VP1322) is secure to the installation tool before using.

Attach the belt clip (VP1322) to the foot of the installation tool using the screw. A corresponding thread and slots are recessed in the

foot of the housing on both sides of the installation tool.

Check at regular intervals that the belt clip (VP1322) is still securely attached. Otherwise, retighten the screw.

SLOTS FOR BELT CLIP (VP1322) (2X)

BELT CLIP (VP1322)

Battery (VP1086) Storage:

Protect the battery (VP1086) from moisture and liquids. Do not leave in car e.g. in the summer.

Store the battery (VP1086) only in optimum temperature range between -22°F (-30°C) and 77°F (25°C). The batteries can be stored as

follows without recharging:

Storage period between -22°F (-30°C) and 77°F (25°C) = 1.5 years

Storage period between -22°F (-30°C) and 113°F (45°C) = 3 months

Storage period between -22°F (-30°C) and 140°F (60°C) = 1 month

A significantly shorter operating time after recharging indicates that the battery (VP1086) is worn out and needs to be replaced.

Observe all local disposal procedures.

GB108A 20V BATTERY INSTALLATION TOOL

HOW TO SET-UP THE GB108A Cont.

process automatically.

SCREW

Image may not

reflect actual tool

8/21