Gage Bilt GB730 User Manual - Page 9

Browse online or download pdf User Manual for Tools Gage Bilt GB730. Gage Bilt GB730 13 pages. Installation tool
Also for Gage Bilt GB730: Installation Manual (14 pages)

Print Page

CLEANING AND LUBRICATING PROCEDURE

Daily cleaning and lubrication of nose assembly will greatly reduce

downtime and increase life of components. Using sewing machine

oil, or an equivalent cleaner/lubricant, follow instructions below.

1. Disconnect tool vacuum line (if equipped).

2. Point nose assembly into oil as shown (Fig. A).

3. Cycle tool 8-10 times and wipe dry.

HEAD

Remove nose assembly from tool before attempting disassembly of head assembly.

Remove end cap (730717). Push against threaded end of head piston (730311) to slide it out of head cylinder (730398). Be careful

not to damage threads or cause burrs on polished piston rod surface.

WARNING:

DISPOSE OF HYDRAULIC FLUID IN ACCORDANCE WITH ALL ENVIRONMENTAL LAWS AND REGULATIONS

APPLICABLE TO YOUR AREA.

The re-assembly sequence is the opposite of disassembly. (See Filling and Bleeding instructions.) Apply Loctite® #242 and torque

the four button-head cap screws (A-928) uniformly to 40 inch lbs. to prevent leakage around the gasket.

200506-2 - PINTAIL TUBE

(FOR USE WITH BLIND RIVETS SMALLER THAN 3/16" Ø)

240102

RETAINING NUT STOP

402482 - BUT. HD. CAP SCREW (2)

S572 - STAT-O-SEAL (2)

730398 - HEAD CYLINDER

401105 - BACK-UP RING

730201 - NOSE FITTING

211102 - NUT

401102 - BACK-UP RING

730311 - PISTON

A-1044 - O'RING

401113 - BACK-UP RING

405889 - O'RING

Fig A.

730717 - CAP

752122 - DEFLECTOR

403841 - O'RING

S945 - O'RING

403812 - O'RING

Rev. 9/11