Gage Bilt GB754 Manual - Page 5
Browse online or download pdf Manual for Tools Gage Bilt GB754. Gage Bilt GB754 13 pages. Installation tool
Print Page
HOW TO USE THE GB745
WARNING:
OPERATOR
WARNING:
IT IS REQUIRED THAT EYE PROTECTION AND HEARING PROTECTION BE WORN DURING
OPERATION.
WARNING:
DO NOT PULL RIVET IN THE AIR. PERSONAL INJURY FROM FASTENER EJECTING MAY OCCUR.
WARNING:
AIR IS EXHAUSTED FROM THE BOTTOM OF THE TOOL. DIRECT BOTTOM OF THE TOOL
(EXHAUSTED AIR) AWAY FROM OPERATOR, OTHER PERSONS WORKING IN THE VICINITY,
FOREIGN MATTER AND LIQUID.
CAUTION:
DO NOT USE BEYOND THE DESIGN INTENT.
The tool is shipped with a plastic plug in the air inlet connector. The connector has a 1/4-18 female pipe thread to accept
end-user air hose fitting. The tool comes with oil and is ready to use.
1. Remove plastic shipping plug from Swivel (A-249) and screw in your air fitting.
2. Attach Deflector (756120) to rear of Head Cylinder (745366).
WARNING:
ROTATE DEFLECTOR AWAY FROM OPERATOR AND OTHER PERSONS WORKING IN THE VICINITY.
3. Connect air hose with 90 psi. (6.2 bar) to tool (3/8 minimum diameter air line is mandatory, 90 p.s.i./6.2 bar is
recommended) and cycle tool a few times by depressing and releasing air actuator ass'y. (Clean dry air is
mandatory).
WARNING:
ENSURE AIR HOSE IS SECURELY CONNECTED TO AVOID POSSIBLE HOSE WHIPPING.
4. Disconnect air hose from tool.
5. Select proper Nose Assembly, screw collet and anvil onto the tool and attach securely. (See proper data sheet for
further instructions.)
6. Connect air supply.
7. Insert rivet into Nose Assembly and the application then depress air actuator ass'y. Upon releasing the air actuator
ass'y the stem will eject to the rear of the tool.
MUST
READ AND UNDERSTAND ALL WARNINGS AND CAUTIONS.
CYLINDER
DEFLECTOR
RED
SHIPPING
PLUG
QUICK
DISCONNECT
FITTING
ASSEMBLY
HEAD
AIR
ACTUATOR
ASSY
Image may not reflect actual tool
5
RIVET
WORK
Rev. 1/14