Gage Bilt GB722 Original Instructions Manual - Page 4
Browse online or download pdf Original Instructions Manual for Power Tool Gage Bilt GB722. Gage Bilt GB722 20 pages. Installation tool
Also for Gage Bilt GB722: Installation Manual (13 pages), Original Instructions Manual (20 pages)
Print Page
WARNING:
Any other use is forbidden.
The GB722/568 is a pneumatic-hydraulic installation tool designed specifically for the efficient installation of 5/32" & 3/16" only HUCKRIMP®
(krimpnuts) with a crimping action that deforms the nut to provide accurate installation loads. It (7.6 mm) fastener setting stroke and
a rated pull load of 4,770 lbs. (21.22 kN) with 90 psi (6.2 bar) air pressure at the air inlet.
The GB722/568 installation tool operates on 90 to 100 psi (6.2-6.9 bar) of air pressure, with 90 psi. (6.2 bar) providing the maximum
efficiency. At 90 psi. (6.2 bar) air pressure, the GB722/568 does not exceed 81.5 dB(A) and consumes .16 SCF/cycle (4.53 L/cycle).
The air inlet is provided with 1/4-18 female pipe thread to accept the users air hose fitting.
NOSE ASSEMBLIES ARE NOT FURNISHED WITH TOOL AND MUST BE ORDERED SEPARATELY.
WARNING:
Do not operate in an explosive atmosphere.
The GB722/568 can be operated between 0ºF - 118ºF (-17.8ºC / 47.8ºC)
GB722/568 INSTALATION TOOL
DESCRIPTION
ENVIRONMENTAL USE
SPECIFICATIONS
Weight (hand held)
- 2.5 lbs. (1.13 kg)
Air pressure req'd
- 90-100 psi. (6.2-6.9 bar)
Air consumption
- .16 SCF/cycle (4.53 L/cycle)
Hydraulic oil
- Automatic Transmission Oil,
Setting stroke
- .300" (7.6 mm)
Rated pull load
- 4,770 lbs. (21.22 kN)
Noise level
- 81.5 dB(A)
Vibration
- Tested – No Hazards Found.
Dexron III, or equivalent.
4
11/21 REV. 5/22