Dawn 5036 Assembly And Operation Manual - Page 16

Browse online or download pdf Assembly And Operation Manual for Farm Equipment Dawn 5036. Dawn 5036 19 pages.

Print Page

START UP PROCEDURE (14.1)

Once all electronic components and hydraulic

components are installed, and pressure tested, you

will be ready to start the initial setup & test procedure.

Power on the Reflex system using the PCAN switch.

You should see the LED lights on the PDM and row

unit controllers come on. If there are no lights, check

cable connections and batter cable.

Once power is established, open the Dawn Reflex

Application on your tablet.

Row unit numbers will show up at the bottom of the

window. If toolbar is raised the rows will be shown in a

white box. When lowered, the box will turn green,

indicating that the down pressure system is active.

At this point, any proximity switched should be

adjusted if they are not activating/deactivating rows

properly. (fig xxx)

ROWS WILL BE SHOWN IN WHITE WHEN TOOLBAR RAISED

ROWS WILL BE SHOWN IN GREEN WHEN TOOLBAR LOWERED

Reflex Operating System

Raise toolbar and ensure there is no load on gauge

wheel arms.

Tap on any row number to access the ROW UNIT

STATUS window. There will be a box in the bottom

left that says "Set zero point on all units". Press this

once. (If done while toolbar lowered, or any gauge

wheel load on wheels, the process will have to be

redone correctly)

Gauge wheel load should be selected by running a

small test strip in the specific field and finding the

proper downforce to produce the desired soil

firmness.

Lower toolbar and establish gauge wheel load. (May

need to roll forward to get row units in the ground)

Gauge wheel load will be displayed at the bottom of

the top bars for each row.

To update the target load, select desired GWL to the

right and push the "Update Setpoint" tab to program.

www.dawnequipment.com

Toll Free: 800.554.0007

Fax:815.899.3663