Dawn 5036 Assembly And Operation Manual - Page 8

Browse online or download pdf Assembly And Operation Manual for Farm Equipment Dawn 5036. Dawn 5036 19 pages.

Print Page

NOTE: With row by row hydraulic downforce, it is

likely that extra weight, or weight distributing hydraulic

cylinders will be required to keep toolbar wings at

proper operational height /angle. Weights should be

added near the ends of the toolbar.

TOOLBAR TIRES (7.1)

If your toolbar was built for the purpose of carrying

striptill equipment, tires on the toolbar should be

properly placed without any correction needed. Many

users will opt for a used planter, or cultivator toolbar.

These toolbars can sometimes work, but gauge

wheels must run in front of the toolbar. Toolbars with

gauge wheels running between strip-till units will not

perform properly. Check that your tires are properly

inflated to the recommended pressure for your

conditions.

HARDWARE INSPECTION (7.2)

Ideally, every piece of equipment, every fastener, and

every accessory is perfect right out of the box. In the

real world, there is a occasional bolt that is not snug,

and an occasional fitting just slightly out of spec. It is

important to inspect your entire system, to ensure that

every bolt is tight and every component is functioning

properly. This simple step can significantly reduce

downtime due to small imperfections amplifying into

equipment failure.

HYDRAULIC INSPECTION (7.3)

Today's hydraulic systems make setup relatively safe

and easy, but it is still important to check all hydraulic

lines and fittings before connecting them to the

tractor. It is recommended that all couplers be fitted

with dust caps when not in use, and carefully cleaned

before connecting. Check for damage on all hydraulic

hoses and replace any lines that have been

compromised by wear or fatigue. High pressure

hydraulic fluid can be dangerous if couplers, lines and

fittings are not properly installed and cared for.

HYDRAULIC CONNECTIONS (7.4)

You should inspect the hydraulic hoses and their

connections. Make sure that the fittings, running into

actuator, center manifold, and all hoses are secure.

Please read and understand the users manual of any

hydraulic accessories and connect pneumatic fittings

according to the recommendations of the

manufacturer.

Toolbar Preparation

TOOLBAR MOUNTED EQUIPMENT (7.5)

Many toolbars used in conjunction with the Pluribus

system carry a number of additional agricultural

devices. Fertilizer hoppers, fertilizer distribution

systems, pneumatic accumulators and pumps, etc.

should be inspected and checked for loose

connections whether electrical, hydraulic or

mechanical. If you do not have an operators manual

for an agricultural device you will be using with the

Pluribus Strip-TIll System, it is highly recommended

that you obtain and review the equipment manual

before using it.

TOOLBAR HITCH (7.6)

Both drawbar and three-point hitches should be

checked for fatigue. Pull-type toolbar hitches should

be equipped with safety chains. Safety chains can

prevent a serious accident should the toolbar hitch

become disconnected from the drawbar.

Unsecured agricultural implements

WARNING!:

can move erratically with extreme force, and may

cause serious injury or death.

www.dawnequipment.com

Toll Free: 800.554.0007

Fax:815.899.3663