Hi-Copy DMX-8631 F User Manual - Page 11

Browse online or download pdf User Manual for Disc Duplicator Hi-Copy DMX-8631 F. Hi-Copy DMX-8631 F 19 pages. Fully stand-alone cd duplicator device

Print Page

9. USB2.0 connection with PC & Mac (DMX-8631U only) :

The DMX-8631U can be connected to PC or Mac through a

USB interface. A USB Storage Driver must be installed on your PC

(or Mac) before the connection is made. Detail about installation can

be found in next section.

Because the limitation of USB specification, only master drive

of DMX-8631U will be identified as the external drive of PC (or

Mac). Factory default CD-RW is the master drive, and please do not

change CD-ROM to master, otherwise, machine might not work.

The procedures to connect with PC (or Mac) :

1. Installed USB Storage Driver as described in next section.

2. Power on PC (or Mac), connect one end of USB cable to USB port

(default USB1.1 or additional USB2.0 host controller) of PC (or Mac).

DMX-8631U

3. Power on

halt RUN key for a period of 5 seconds, all three LEDs on the front

panel will light up, it then switched to USB linked to PC mode.

4. Connect another end of USB cable to back panel of

5. PC (or Mac) will identify the external IDE drive. A Removal Icon is

also generated to allow you to remove the drive. This icon is displayed

at the lower right corner on the PC screen. At this moment, you can

use PC (or Mac) CD burning software such as CDcreator, Nero5.5,

(for PC) or Toast (for Mac) to write the CD. Remember to open

memory buffer of Nero to 63MB to get the best performance.

The procedures to disconnect with PC (or Mac) :

1. Click Remove Icon or drag drive to Trash to safely remove the drive.

2. Disconnect USB cable from back panel of

DMX-8631U

3. Power off

** Note ** :

DMX-8631E/F/U Installation Guide

, after buzzer sounds a short beep, press and

DMX-8631U