Adelberg AKF21A200 Instruction Manual - Page 10
Browse online or download pdf Instruction Manual for Freezer Adelberg AKF21A200. Adelberg AKF21A200 13 pages.
Print PageINSTALLATION INSTRUCTIONS
Before Using Your Freezer
Remove the exterior and interior packing.
Check to be sure you have all of the following parts:
1 Storage Basket
1 Instruction Manual
1 Plastic Scraper
Before connecting the freezer to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Installing Your Freezer
This appliance is designed to be free standing only, and should not be recessed or built-in.
Place your freezer on a floor that is strong enough to support the freezer when it is fully loaded.
Allow 15 cm of space between the back and sides of the freezer, which allows the proper air
circulation.
Locate the freezer away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the freezer not to perform
properly.
Avoid locating the freezer in moist areas.
Plug the freezer into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.
After plugging the appliance into a wall outlet, allow the unit to cool down for 2~3 hours before
placing food in the freezer compartment.
Electrical Connection
OPERATING YOUR FREEZER
Temperature Control
Your freezer has one control for regulating the temperature. The temperature control is located on
the lower right hand corner.
The range of the temperature control is from position" 1" the warmest to "6" the coldest. Adjust
the temperature control to the setting that best suits your needs. The setting of "4" should be
appropriate for home or office freezer use.
When turn to "6", the freezer getting "fast freeze" and the compressor will not stop until you turn
the button to the other position.
To turn the freezer off, turn the temperature control to "OFF".
NOTE:
Turning the temperature control to "OFF" position stops the cooling cycle but does not shut off the
power to the freezer.
If the unit is unplugged, lost power, or turned off; you must wait 3 to 5 minutes before
Restarting the unit. If you attempt to restart before this time delay, the freezer will not start.
Large amounts of food will lower the cooling efficiency of the appliance.
If you choose to change the thermostat setting, adjust thermostat control by one numerical
For your safety please read the following information